Stamina Products 15-0100 - Manual (Page 9)

STORAGE
To store the hi-lo Cycle 100 simply keep it in a clean dry place.
The hi-lo Cycle 100 is 16 1/8" long (min.) x 16" wide x 17 3/4" tall.
Grasp the Front and Rear Stabilizer to move the hi-lo Cycle 100. Do not use the Pedals to move the
hi-lo Cycle 100. The Pedals will move and the Crank may pinch your hand or fingers.
To avoid damage to the electronics, remove the batteries before storing the hi-lo Cycle 100 for one
year or more.
1.
2.
3.
4.
9
MAINTENANCE
The safety and integrity designed into the hi-lo Cycle 100 can only be maintained when the hi-lo Cycle
100 is regularly examined for damage and wear. Special attention should be given to the following:
Adjust the TENSION KNOB(26) and verify that the TENSION BELT(24) provides tension. The
TENSION BELT(24) should provide many years of use.
Verify that the Pedals are tightened securely. If tightening is required, remember that the left Pedal has
left hand threads and is tightened by turning counterclockwise.
Do not step on any portion of the plastic cover when using the
hi-lo Cycle 100 . This can cause the
plastic cover to crack.
It is the sole responsibility of the user/owner to ensure that regular maintenance is performed.
Worn or damaged components shall be replaced immediately or the
hi-lo Cycle 100 removed from
service until repair is made.
Only Stamina Products supplied components shall be used to maintain/repair the
hi-lo Cycle 100.....
Keep your hi-lo Cycle 100 clean by wiping with an absorbent cloth after use.
1.
2.
3.
4.
5.
6.
7.