Tension belt adjustment, Load adjustment – Stamina Products 15-0100 User Manual

Page 8

TENSION BELT ADJUSTMENT

Should the tension system not fulfill your needs it can be
readjusted following this procedure:

Turn the

TENSION KNOB(26)

to the loosest setting (counter-clockwise).

Lift the tab on the

BUCKLE(23)

to release the grip on the

TENSION BELT(24).

If the tension is too loose, tighten the

TENSION BELT(24)

1/4" and reset the

BUCKLE(23).

If the tension is too tight, loosen the

TENSION BELT(24)

1/4" and reset the

BUCKLE(23).

Pedal to test the tension. If it is still not adequate continue to adjust the

TENSION BELT(24)

1/4" at a

time until it is right for you.

1.
2.
3.

Upper Body:

Place the bike on a table or desk. Grasp the pedals

firmly with your hands and pedal the bike. This exercise can be
performed while seated or standing.

Lower Body:

Place the bike on the floor in front of a chair. Sit in

the chair and pedal the bike with your feet.

Caution:

Do not stand up on the

hi-lo Cycle 100.

EXERCISE WORKOUT

OPERATIONAL INSTRUCTIONS

FRONT STABILIZER ADJUSTMENT

Pull the

FRONT STABILIZER(2)

out for use. Push the

FRONT STABILIZER(2)

in for storage. Adjust the

FRONT STABILIZER(2)

by loosening the

LOCKING

KNOB(31),

then slide the

FRONT STABILIZER(2)

adjust the position. Tighten the

LOCKING KNOB(31).

LOAD ADJUSTMENT

To increase the load, turn the

TENSION KNOB(26)

clockwise. To decrease the load, turn the

TENSION

KNOB(26)

counterclockwise.