Assembly instructions – Stamina Products 15-0100 User Manual

Page 6

STEP 1:

Insert the

FRONT STABILIZER(2)

into the

MAIN FRAME(1)

and lock in position with the

LOCKING KNOB(31).

NOTE:

STEP 2

NOTE:

Thread the

RIGHT PEDAL(6)

onto the right side of the

CRANK(7)

as shown. Tighten the pedal securely.

Do the same to attach the

LEFT PEDAL(5)

onto the left side of the

CRANK(7).

STEP 3:

Install two

"AA"

batteries into the back of the

METER(29).

Plug the

SENSOR WIRE(28)

the

METER(29),

then slide the

METER(29)

onto the Bracket on the

MAIN FRAME(1).

ASSEMBLY INSTRUCTIONS

Place all parts from the box in a cleared area and position them on the floor in front of you. Remove all
packing materials from your area and place them back into the box. Do not dispose of the packing materials
until assembly is completed. Read each step carefully before beginning. If you are missing a part please
call our toll-free number for assistance 1 (800) 375-7520 or e-mail us at: [email protected]

The

RIGHT PEDAL(6)

has

stamped on the end of the pedal shaft. The

RIGHT PEDAL(6)

has right hand threads and is tightened by turning clockwise. The

LEFT PEDAL(5)

has

stamped

on the end of the pedal shaft. The

LEFT PEDAL(5)

has left hand threads and is tightened by

turning counter clockwise.

RIGHT

BRACKET

Pull the

FRONT STABILIZER(2)

out for use. Push the

FRONT STABILIZER(2)

in for storage.

Adjust the

FRONT STABILIZER(2)

by loosening the

LOCKING KNOB(31),

then slide the

FRONT STABILIZER(2)

to adjust the position. Tighten the

LOCKING KNOB(31).

LEFT