Sharp AR-163 - Manual (Page 40)

38
GENERAL INFORMA
TION
USER PROGRAMS
User programs
Settings for auditing accounts
Settings of user programs No. 10 to 15 varies with the program number. For
setting of all programs, first follow steps 1 to 3 in “Setting the user programs”
on page 36 to select a program. (1. Press the light (
) key for more than 5
seconds. 2. Enter a program number (10 to 15) using the numeric keys. 3.
Press the START (
) key.) Then follow the appropriate instructions for the
program.
Program No. 10: Auditing mode
If the auditing mode is enabled, copying is limited to operators with an
assigned 3-digit account number. A maximum of 20, 3-digit account numbers
can be assigned. Use program No. 11 to register account numbers.
When program No. 10 is entered, the current setting (0: OFF, 1:ON) will
blink on the right side of the copy quantity display.
1. Select the desired setting using the numeric keys.
0: OFF
1: ON
2. Press the START ( ) key.
● The setting will be stored.
3. To continue with other user programs, press the key
and enter another program number. To exit the user
program mode, press the light (
) key.
1. Enter a 3-digit account number using the numeric keys.
● Any 3-digit number except “000” can be registered as an account
number.
2. Press the START ( ) key.
● If a number that is already registered or “000” is entered, the number
will blink in the copy quantity display.
3. Repeat steps 1 and 2 for other account numbers.
4. To continue with other user programs, press the key
and enter another program number. To exit the user
program mode, press the light (
) key.
Program No. 11: Account number entry
Program No. 11 is used to register accounts. When program No. 11 is entered,
“
– – – ” will blink in the copy quantity display.
● If the number of accounts has reached the upper limit (20), “11E” will
appear in the copy quantity display. Press the
key. The copier will
return to step 2 on page 36.