Sharp AR-163 - Manual (Page 22)

20
MAKING COPIES
TWO-SIDED COPYING
Two-sided copies can be made on this copier using the bypass tray.
1 Place the first original on the original table and make a
copy.
● The first copy can be made using any of the paper feed stations.
2 Replace the first original with the second original and
close the platen cover.
● Make sure that the first and second originals are oriented in the same
way on the original table.
● When the originals are placed horizontally, make sure that the first and
second originals are oriented in the reverse way on the original table.
3 Turn the first copy over left to right and place it into the
bypass tray.
● Be sure to feed the copies one sheet at a time.
Depending on the copy paper quality, the copy may curl
up. If the copy has curled up, be sure to perform the
following steps before copying onto the reverse side to
avoid a misfeed.
1. Flatten the copy paper.
2. Change the orientation of the original and copy
paper. (For example, change A4 (8-1/2" x 11") to
A4R (8-1/2" x 11"R).)
4 Use the TRAY SELECT ( ) key to select the bypass
tray.
5 Press the START ( ) key.
Two-sided copying