Seiko 5J32A - Manual (Page 11)

11
TECHNICAL GUIDE
Cal. 5J32A
27 Oscillating weight bridge
29 Intermediate wheel for generating rotor
32 Generating rotor
· Lubricate the ball-bearing of the oscillating weight bridge as shown below before reassembling it to
the main plate.
· Lubricate the upper and lower pivots and other portions of the generating rotor and intermediate
wheel for generating rotor as shown in the illustration.
Oscillating weight bridge Intermediate wheel for generating rotor
Intermediate wheel
for generating rotor
Generating
rotor
Note: Be sure to observe the position, type of oil and quantity of the lubrication specified in the
illustration.
28 Circuit block
The portions indicated by the arrows in the
illustration have elasticity and are made tight for
the guide tubes to which they are set. After
setting the circuit block, press down those
portions to make sure that it is well seated.
34 Second wheel and pinion
35 Intermediate second wheel
36 Fourth wheel and pinion
37 Third wheel and pinion
38 Second rotor
39 Hour and minute rotor
40 Setting wheel
41 Intermediate minute wheel
42 Minute wheel and pinion
For the discrimination and setting position of these parts, refer to the table on the next page.
Lubricating: : Moebius A