Sanyo DWM-2600 - Manual (Page 40)

-E39-
SHIFT
SLEEP
MAINTENANCE
WARNING:
FOR YOUR PERSONAL SAFETY, BE SURE TO
DISCONNECT THE AC POWER CORD BEFORE
PROCEEDING WITH ANY MAINTENANCE OR CLEANING.
Cleaning the cabinet
Use a clean soft cloth moistened with plain lukewarm water and
wrung dry. Never use benzol, benzene or other strong chemical
cleaners since these could damage the finish of your unit. It is
important that no liquid reaches the inside of the unit.
The sleep timer automatically switches off the power after a
preset time has elapsed. The volume will gradually be reduced
(fade-out) during the 1 minute period before the unit turns off.
There are 4 time periods available: 30, 60, 90, and 120 minutes.
Press [SLEEP] repeatedly while holding [SHIFT] down to select
the desired sleep time. “SLEEP” appears, and the selected time
blinks on the FL display.
After several seconds, the original display returns and the
brightness of the display reduces.
To check the remaining sleep time
Press [SLEEP] once while holding [SHIFT] down. The remaining
time is displayed.
After several seconds, the original display returns.
To release the sleep timer while in operation
Press [SLEEP] repeatedly while holding [SHIFT] down until
“SLEEP OFF” appears.
The timer is also released if the power is switched off.
SLEEP TIMER OPERATION
If you have followed the instructions and are having difficulty operating the unit, locate the SYMPTOM in the left column below. Check
the corresponding POSSIBLE CAUSE and CORRECTIVE ACTION columns to locate and remedy the problem.
SYMPTOM
No power.
The power is on, but the player does not
work.
No picture.
POSSIBLE CAUSE
No power plug connection at the AC wall outlet.
No disc is loaded.
An unplayable disc is loaded.
The TV is not set to receive signal from the unit.
The video cable is not connected.
“PROGRESSIVE” mode is set.
CORRECTIVE ACTION
Insert the power plug into the AC wall outlet.
Load a disc.
Load a playable disc. (Check the disc logo, type,
color system and region number.) (See page E15.)
Select the correct input function on the TV.
Connect the video cable into the jack.
Select “INTERLACE” mode. (See page E16.)
TROUBLESHOOTING GUIDE
Need help? Call
1-800-813-3435
DWM-2600 Page E1-E43.p65 03.12.22, 11:35 AM 39