Snapper 522E - Manual (Page 19)

17
Troubleshooting
& Service
Figure 12. Chute Removal and Installation
A. Chute
B. Fastners
A
B
B
B
B
CHUTE REMOVAL AND
INSTALLATION
1. Remove the fasteners (B, Figure 12) that secure the
chute (A) to the top cover.
2. Remove the chute (A).
3. Installation is reverse of removal.
TROUBLESHOOTING
Problem Possible Cause Remedy
Engine fails to start 1. Key is OFF 1. Turn Key to the ON position
2. Failure to prime cold engine 2. Press primer button twice and restart.
3. Out of fuel 3. Fill fuel tank
4. Choke OFF - cold engine 4. Turn Choke to ON.
5. Engine flooded 5. Turn Choke to OFF; try starting
6. Spark Plug not sparking 6. Check Gap. Gap plug, clean electrode,
or replace as necessary
7. Water in fuel, or old fuel 7. Drain tank (Dispose of fuel at an authorized
waste facility). Fill with fresh fuel mixture.
Engine starts hard or runs poorly 1. Fuel mixture too rich 1. Move choke to OFF position
2. Spark plug faulty, fouled, 2. Clean and gap, or replace
or gapped incorrectly
3. Water in fuel, or old fuel 3. Drain tank (Dispose of fuel at an authorized
waste facility). Fill with fresh fuel mixture.
4. Gas cap vent hole plugged 4. Clean vent hole or replace cap
Unit does not throw snow 1. Loose or broken drive belt 1. Adjust or replace belt
2. Incorrect control cable 2. Adjust Auger Control cable
adjustment
3. Discharge chute clogged, 3. Stop engine, remove key and
foreign object lodged in auger clean out discharge chute
4. Broken control cable 4. Replace cable
Auger does not stop turning 1. Incorrect control cable 1. Adjust Auger Control cable
when control is released adjustment
Excessive vibration 1. Loose parts or damaged 1. STOP engine and REMOVE the key,
auger tighten all hardware. If vibration
continues, see your dealer.
Note: For repairs beyond the minor adjustments listed above, please contact your local dealer.