Snapper 522E - Manual (Page 15)

13
ADDING ENGINE OIL
1. Make sure the unit is level. Use a high quality deter-
gent oil classified “For Service SG, SH, SJ, SL, or
higher”.
2. Remove the oil fill cap/dipstick access panel (A,
Figure 9).
2. Remove the oil fill cap/dipstick (B) and wipe with a
clean cloth.
3. Insert the oil fill cap/dipstick (B) and turn clockwise to
tighten.
4. Remove the oil fill cap/dipstick (B) and check the oil.
NOTE: Do not check the level of the oil while the engine
is running.
5. If necessary, add oil until the oil reaches the FULL
mark on the oil fill/cap dipstick (see Figure 9). Do not
add too much oil.
6. Tighten the fill cap/dipstick securely each time you
check the oil level.
NOTE: For extreme cold operating conditions of 0°F(-18°
C) and below, use a synthetic 5W30 motor oil for easier
starting.
NOTE: S.A.E. 5W30 motor oil may be used to make
starting easier in areas where the temperature is 20° F
(-7° C) to 0F (-18° C). Synthetic 5W30 is acceptable for
all temperatures. DO NOT mix oil with gasoline.
NOTE: SEE CHART FOR OIL RECOMMENDATION
ADDING FUEL
To add fuel:
1. Remove the fuel cap (C, Figure 9).
2. Fill the tank. Do not overfill. Leave room in the tank
for fuel expansion. Fill the fuel tank with fresh, clean,
unleaded regular, un-leaded premium, or reformulat-
ed automotive gasoline with a minimum of 85 octane
along with a fuel stabilizer (follow instructions on fuel
stabilizer package). DO NOT use leaded gasoline.
Controls & Operation
Figure 9. Add / Check Engine Oil and Gasoline
A. Access Panel
B. Oil Fill Cap/Dipstick
C. Fuel Cap
A
C
B
WARNING
Gasoline is highly flammable and must be
handled with care. Never fill the tank when the
engine is still hot from recent operation. Do not
allow open flame, smoking or matches in the
area. Avoid over-filling and wipe up any spills.
Do not use gasoline containing METHANOL,
gasohol containing more than
10% ETHANOL, gasoline additives, or white
gas because engine/fuel system damage
could result.
We recommend that fuel stabilizer be added to the
fuel each time that gasoline is added to the fuel tank.
Refer to your engine manual for further specific fuel
recommendations.
3. Install and hand tighten the fuel cap.
NOTE: Winter grade gasoline has higher volatility to
improve starting. Be certain container is clean and
free from rust or other foreign particles. Never use
gasoline that may be stale from long periods of stor-
age in the container.
CAUTION: DO NOT use gasoline containing any amount
of alcohol as it can cause serious damage to the engine
or significantly reduce the performance
Use oil classified API Service Class SF,
SG, SH, SJ or better with SAE Viscosity:
40 20 0 32 -20
4 -7 -18 0 -30
˚F
˚C
5W-30 Conventional
5W-30 Synthetic