Subaru Impreza 2004 - Manual (Page 45)

ME(H4DOTC)-44
MECHANICAL
Engine Assembly
9. Engine Assembly
A: REMOVAL
1) Set the vehicle on a lift.
2) Open the front hood fully, and then support with
the hood stay.
3) Collect the refrigerant from A/C system.
4) Release the fuel pressure.
(1) Disconnect the fuel pump relay connector.
(2) Start the engine, and run until stalls.
(3) After the engine stalls, crank it for 5 seconds
more.
(4) Turn the ignition switch to OFF.
5) Remove the filler cap.
6) Disconnect the ground cable from battery.
7) Remove the radiator from vehicle. CO(H4DOTC)-23, REMOVAL, Radiator.>
8) Remove the coolant filler tank. CO(H4DOTC)-33, REMOVAL, Coolant Filler
Tank.>
9) Disconnect the A/C pressure hoses from A/C
compressor.
10) Remove the intercooler. 10, REMOVAL, Intercooler.>
11) Disconnect the following connectors and cable.
(1) Engine harness connector
(2) Engine ground terminal
(3) Engine harness connector
(4) Generator connector, terminal and A/C
compressor connectors
FU-00871
FU-00009
ME-00707
(A) A/C compressor connector
(B) Generator connector and terminal
ME-00027
ME-00028
ME-00029
ME-00030
(A)
(B)