References, N if trouble occurs, If such a problem occurs, do the following – Sharp DK-A10 User Manual
Page 29: N clearing all the memory (reset), Graphic, N before transporting the unit, Maintenance, N cleaning the cabinet, Specifications, N general
29
DK-A10
DK-A10BK
References
If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1
Set the unit to the stand-by mode and turn the power on again.
2
If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
Clearing all the memory (reset)
1
Press the ON/STAND-BY button to enter the power stand-by
mode.
2
While pressing down the SNOOZE/DIMMER button and the
E SOUND/DEMO button, press the ON/STAND-BY button until
“CLEAR ALL” appears.
Caution:
This operation will erase all data stored in memory including clock,
alarm settings and tuner preset.
Before transporting the unit
Remove the iPod and the disc from the unit. Then, set the unit to the
power stand-by mode. Carrying the unit with iPod left docked might
damage both the unit and the iPod.
Maintenance
Cleaning the cabinet
Periodically wipe the cabinet with a soft cloth and a diluted soap
solution, then with a dry cloth.
Caution:
Do not use chemicals for cleaning (gasoline, paint thinner, etc.). It
may damage the cabinet finish.
Do not apply oil to the inside of the unit. It may cause malfunctions.
Specifications
As part of our policy of continuous improvement, SHARP reserves
the right to make design and specification changes for product
improvement without prior notice. The performance specification
figures indicated are nominal values of production units. There may
be some deviations from these values in individual units.
General
Tuner
SNOOZE/
DIMMER
E SOUND
/DEMO
Power source AC 120 V, 60 Hz
Power
consumption
33 W
Output power Front speakers: RMS: 4W (2W + 2W) (10% T.H.D.)
Subwoofer: RMS: 10W (5W + 5W) (10% T.H.D.)
Speaker
1-way type light-up speaker system
Front Speaker: 2-1/2"(6.5 cm) - 12 ohms - Full Range
Subwoofer: 4" (10 cm) - 8 ohms - Full Range
Speaker
maximum
input power
Front Speakers: 4W
Subwoofer: 10W
Speaker rated
input power
Front Speakers: 2W
Subwoofer: 5W
Output
terminals
Headphones: 16 - 50 ohms
(recommended: 32 ohms)
Video output: 1Vp-p
Input
terminals
Auxiliary (audio signal):
500 mV/47 k ohms
Dimensions
Width: 19-11/16" (500 mm)
Height: 5-7/8" (150 mm)
Depth: 9-7/8" (250 mm)
Weight
11.7 lbs. (5.3 kg)
Frequency range
FM: 87.5 - 108 MHz
AM: 530 - 1,720 kHz