Soundstream Technologies 1002 - Manual (Page 4)

Front View
8
-16
-17
-18
1.
2.
3.
4.
5.
6.
8.
9.
10.
I l .
12.
13.
14.
15.
16.
17.
18.
19.
KEY TO
Power LED Indicates amplifier power, either in High Power or Auto High
Current.
Clip Indicators Indicates the signal output level is too high and the output
stage of the amplifier is clipping.
Subsonic, Hawkins Bass Control, H.P. Xover Switch Selectable high pass
filter frequency range. Select “SUB SONIC” to engage the Sub Sonic filter
with no boost. Use the knob indicated by
to set the frequency:
Select “Hawkins Bass Control” to engage the Sub Sonic filter
with available boost. Use the knob indicated by to set the
frequency: 30 Hz to 70 Hz. Select XOVER” to engage the amplifier’s
high pass filter for running satellite speakers. Use the knob indicated by
to set the frequency: 70-I 60 Hz.)
Low Pass XOVER Switch Selectable low pass filter for driving subwoofers.
Use the knob indicated by to set the low pass frequency. Note:
Do not have the XOVER” and the XOVER” engaged at the same
time.
MONO/SUM/ST Switch “MONO” for bridged mono operation with a single
input signal (right channel only). ‘SUM” for bridged mono operation sum-
ming two input signal (left and right). for normal stereo operation,
Left Channel Balanced/Unbalanced Input Selector Select “BALANCED”
to use the 6 pin Balanced signal input. Select “UNBALANCED” to use the
RCA signal inputs.
Right Channel Balanced/Unbalanced Input Selector Select “BALANCED”
to use the 6 pin Balanced signal input. Select “UNBALANCED” to use the
RCA signal inputs.
RCA
Inputs Right and Left channel RCA (Unbalanced) inputs.
Balanced Signal Input Connector 6-Pin Balanced input connector for use
with the Soundstream Balanced Line Trasmitter.
Input Levels Independent Left and Right input level controls.
Hawkins Bass Control “Boost” Adjustment Varies from 0 to of
boost when the Hawkins Bass Control circuit is engaged.
High Pass Filter Control Adjustment Frequency adjustment control for the
High Pass filter, the Hawkins Bass Control filter, or the Sub Sonic filter.
Low Pass Filter Control Adjustment Frequency adjustment control for the
Low Pass filter.
Line Outputs Line level RCA outputs to drive an external amplifier (Note:
The outputs are full-range.)
Speaker Connection Terminal Speaker connections for Ch’s 1 2.
REMOTE Remote turn-on input from the head unit. Accepts
GND Main ground connection. Bolt to a clean chassis point in the vehicle.
Connected to a fuse or circuit breaker, then to the battery’s positive
terminal
FUSE Main power supply fuse. Warning: Replace only with the same
value fuse!