Soundstream Technologies 1002 - Manual (Page 10)

TRIDENT CIRCUITRY SERVICE
Your amplifier is protected against both overheating and short circuits
by means of main power fuses and the following circuits:
Auto High Current power supply
Protection
Your Soundstream amplifier is protected by a limited warranty.
Please read the enclosed warranty card for details.
Ground Fault Differential 4 Stereo 2 Stereo 1 Stereo
Smart Power Supply Thermal Rollback a Thermal Protection Circuit
POWER (8 Bridged) (4 Bridged) (2 Bridged)
(12.6 Vdc) (14.4 Vdc) (14.4 Vdc)
x2 250w x 2 250w x 2
502
x 1) x 1) x 1) If you experience blown main power supply fuses, it is
that the amplifier is seeing a dead either in the speaker wire or in
the speaker itself. Rectify the problem before blowing fuses!
DO NOT increase values beyond fhe original fuse value! Doing so will
void your warrant and may damage your amplifer.
TROUBLESHOOTING
PROBLEM CAUSE
1. No power or ground at the amp.
No Sound and power LED is not lit 2. No remote turn-on signal
3. Blown fuse near the battery
1. No signal input
No sound, power LED is lit.
2. The switch
is in the position. Move it to the
“OUT” position.
Repeatedly blow amp fuse;
frequent activation of Smart Power
1. Speaker or leads may be shorted
Supply Circuit
2. Verify adequate amp ventilation
Not enough input sensitivity while
Be sure both Left and Right input
using the Balanced Input
signal switches are set to the
position.
Very little output, or output is
muffled.
Make sure that the L.P. and
the H.P. aren’t
engaged
Left and Right “Clip” indicators
lighting
Output signal level is too high and
the amplifier output is clipping.
Reduce the level either at the
source
or at the input level controls.
1. Make sure the Right Input Signal
Switch is in the position.
Alternator whine while using
Unbalanced RCA inputs
2. Try the Left Input Signal switch
in the “BAL” and “UNBAL” position:
leave the switch in the quietest
setting. This will not effect the
performance of the amplifier.
18
Maximum
Rated
output
500 Watts
700 Watts
1000 Watts
THD
Signal to Noise
Frequency Response 20 Hz to 20 0.5
Stereo Separation
Damping
input Sensitivity 300 to 5.0 Volts
Input Impedance Ohms
Crossover Specifications
Low Pass: 55 Hz 220 Hz at 24
High Pass: 70 Hz 160 Hz at 12 dB/Octave
Hawkins Bass Control
Sub Sonic Filter: No boost, High Pass filter from 13 to 30 Hz.
Hawkins Bass Control: 0 to Boost; Boost and Sub Sonic filter,
variable from 30 to 70 Hz.
Dimensions (W x D x H)
RUB
RUB
RUB CON502: 11 X 9.8” X 2.25”
CON702:
13.0” X 9.8” X 2.25”
CON1002: 15.0” X 9.8” X 2.25”
19