Sony RM-AV3100 User Manual

Page 38

Executing a Series of Commands
— System Control Functions
(continued)

Press the YES key.

YES

While erasing, “

c c c c” stays lit.

When all settings programmed for the
Component Select buttons and
corresponding Label keys are erased,
“OK” is displayed with a beep sound.

If you press the NO key

The display returns to Step 1.

Press COMMANDER OFF.

COMMANDER

OFF

If you keep COMMANDER OFF
pressed for more than 2 seconds

The Commander turns off.

If you keep COMMANDER OFF
pressed for less than 2 seconds

The Commander returns to the previous
setting mode.

To erase the SYSTEM CONTROL 1
or 3 button

At the factory, the SYSTEM CONTROL 1
button is preset with a series of power-off
commands for Sony components and the
SYSTEM CONTROL 3 button with a
series of power-on commands for Sony
components.
To erase the programmed commands for
each button, follow the steps below.

1 While pressing COMMANDER OFF,

press MUTING.

2 Press the SYSTEM key on the display.
3 While pressing the DEL key, press the

SYSTEM CONTROL 1 or 3 button.
The program for the selected button is
erased.

To set the SYSTEM CONTROL 1 or
3 button back to the factory
setting

To reset them to the factory settings,
follow the steps below.

1 Clear the “learned” function (See “To

clear the learned function of a single
key or button,” page 26.) or the System
Control function (See “To clear
programmed commands for a specific
SYSTEM CONTROL button or
corresponding Label key,” page 36.)
programmed on SYSTEM CONTROL 1
or 3.

2 Clear again the System Control

function programmed on SYSTEM
CONTROL 1 or 3 (page 36).
Select SYSTEM CONTROL 1 or 3, in
Step 5 on page 36.

Note

The interval setting (page 41) is not reset to the
factory setting, even if you perform these steps.