Smeg CIR34XS - Manual (Page 17)

Instructions for the user
19
7 USING THE HOB
Before turning on the burners, make sure that the burner rings, caps
and grids have been fitted correctly.
In the wok burner, notch
A must be aligned with pin B.
Grid C provided is intended for use with woks (Chinese pans).
Adapter D comes only with open grids models and is intended for use
with small sized vessels.
7.1 Ignition of the burners
The device is fit with electronic ignition. Simply press and
simultaneously turn the knob counter-clockwise on the high flame
symbol, until the burner is ignited.
In models with safety valve, the knob
has to be turned to the ignition symbol before it is pressed, and after
ignition the knob has to be kept pressed for about 2 seconds to keep
the flame lit and to activate the safety device
The burner might go off when the knob is released. In this case repeat
the aforesaid operation keeping the knob pressed for more than 2
seconds.
Should the burners go off accidentally in the models with valves, a
safety device will trip after approximately 20 seconds to block the gas
outlet even if the cock is open.
7.2 Practical advice for using the burners
For better burner performance and minimum gas
consumption, flat bottomed, even recipients must be
used, with covers and proportional in size to the
burners (see paragraph “
7.3 Diameter of containers”).
To avoid overcooking or damage to the surface top
while cooking, all recipients or griddles must be
positioned within the cooking hob perimeter and must
be a minimum distance of 3-4 cm from the knobs.