beautypg.com

Installing the washing machine, Selecting a location, Adjusting the leveling feet – Samsung B1113J User Manual

Page 7: Removing the transit bolts, Connecting the water supply hose

background image

SELECTING A LOCATION

Before you install the washing machine, select a location with the following characteristics:

A hard, level surface (if the surface is uneven, see "Adjusting the leveling feet," below)

Away from direct sunlight.

Adequate ventilation

Room temperature that will not fall below 0 ûC

Away from sources of heat such as coal or gas

Make sure that the washing machine does not stand on its power cord.
Ventilation openings must not be obstructed by carpeting when the washing machine is
installed on a carpeted floor.

ADJUSTING THE LEVELING FEET

If the floor is uneven, adjust the feet (do not insert pieces of wood or any other objects under
the feet):

1.

Loosen the leg bolt by turning it with your hand until it is at the desired height.

2.

Tighten the locking nut by turning it with the supplied wrench.

Place the washer on a sturdy, flat surface.

If the washer is placed on an uneven or weak surface, noise or vibration occurs.

(Only a l degree angle is allowed.)

REMOVING THE TRANSIT BOLTS

Before using the washing machine, you
must remove the five transit bolts from
the back of the unit. To remove the
bolts:

1.

Loosen all bolts with the supplied wrench before removing them.

2.

Take each bolt head and plastic together, pull it through the wide part of the hole.
Repeat for each bolt.

3.

Fill the holes with the supplied plastic covers.

4.

Keep the transit bolts for future use.

CONNECTING THE WATER SUPPLY HOSE

The water supply hose must be connected to the washing machine at one end and to the
water faucet at the other. Do not stretch the water supply hose. If the hose is too short and
you do not wish to move the water faucet, replace the hose with a longer, high pressure
hose.

To connect the water supply hose:
1.

Take the L-shaped arm fitting for the cold
water supply hose and connect to the cold
water supply intake on the back of the
machine. Tighten by hand.

SAMSUNG

Washing Machine Owner

s Instructions

5

Installing the Washing Machine

B1113J-GB-01527E 4/15/02 03:02 PM Page 5