Samsung B1113J - Manual (Page 14)

Washing a Load of Laundry
12 SAMSUNG Washing Machine Owner ’ s Instructions
WASHING CLOTHES MANUALLY
You can wash clothes manually without using the Fuzzy Logic feature. To do so:
1. Turn on the water at the water source sink.
2. Press the (On/Off) button on the washing machine.
3. Open the door.
4. Load the articles one at a time loosely into the drum, without overfilling.
5. Close the door.
6. Put the detergent and, if necessary, softener or chlorine bleach, in the appropriate
compartments.
7. Press the Wash/Rinse Temperature button to select the water temperature
(Warm/Cold➔ Warm/Warm➔ Hot/Cold ➔ Cold/Cold )
8. Press the Spin button to select the spin speed, [no, rh, 400, 600, 800, 900 and 1000, 1100
revolutions per minute(rpm)].
Note: The rinse hold program allows you to take clothes that are dripping wet out of
the washing machine.
no : No Spin, rh : Rinse Hold.
9. Press the Extra Rinse button to select the Extra Rinse (if needed).
10. Press the Start/Pause button and the machine will begin the cycle.
When the cycle is finished:
1. Open the door.
Note: The door will not open until 3 minutes after the machine stops or
the power turns off.
2. Remove laundry.
USING DELAY START
You can set the washing machine to start your wash automatically at a later time, choosing
from a 1 to a 24 hour delay (in 1 hour increments).
To do this:
1. Manually or automatically set your washing machine for the type of clothes you are
washing.
2. Press the Delay Start button repeatedly until the delay time is set.
3. Press the Start/Pause button. The Delay Start indicator will light, and the clock will
begin counting down until it reaches your start time.
4. To cancel Delay Start, press the (On/Off) button, then turn the washing machine on
again.
B1113J-GB-01527E 4/15/02 03:02 PM Page 12