Sanus Systems VM200 User Manual

Page 2

Step 1: Mount Monitor Brackets to a television with a flat back

NOTE: For televisions with a curved back, or an obstruction near the threaded insert see Step 2.

Determine the diameter of the Bolt (

G,H,I) your TV requires by hand threading them into the threaded insert on the back of the TV. If you

encounter any resistance stop immediately.

Once you have determined the correct diameter, see the appropriate Diagram below, thread the Bolt through the appropriate Lock Washer

(

M,N,O), corresponding Washer (P,Q), Monitor Bracket (B,C), and finally into the TV.

Make sure the Monitor Brackets (

B,C) are vertically centered and level with each other.

Tighten the Bolts (

G,H,I) securing the Monitor Brackets (B,C) to the monitor.

Diameter Bolt

Diagram 1

Tension

Knob

Tension

Knob

NOTE: If the horizontal distance between the

threaded inserts on the back of the television

is greater than 8-1/8 inches [206 mm] but less

than 11-1/8 inches [282.5 mm], the locations of

the Monitor Brackets (B & C) may be reversed

from right to left. If the Monitor Brackets

are reversed, the Tension Knobs must be

removed and reinstalled so that they are still

facing out.