Sanyo 32LM5R - Manual (Page 16)

Ver. Page 15
7.7 Signal status Read Command
Command “CR SIGNAL” [CR]
Detail Get the signal status.
Response
Acceptable “%1” [CR]
%1
“000 No signal = No signal
“000 Signal exists” = Signal exists.
Unacceptable “%1” [CR]
7.8 Child lock setting Read Command
Command “CR CHILD” [CR]
Detail Get the child lock setting.
Response
Acceptable “%1” [CR]
%1
“000 OFF” = OFF
“000 ON” = ON
Unacceptable “%1” [CR]
7.9 Power save setting Read Command
Command “CR PSAVE” [CR]
Detail Get the PSAVE setting .
Response
Acceptable “%1” [CR]
%1
“000 OFF” = OFF
“000 ON” = ON
Unacceptable “%1” [CR]
7.10 Panel usage time Read Command
Command “CRTM” [CR]
Detail Get the Panel Usage Time
Response
Acceptable “%1” [CR]
%1
Panel Usage Time in hour by 5 digits.
Ex.
“00123” This means 123 hours
Unacceptable “?” [CR]
7.11 RC inhibition Read Command
Command “CR RMC” [CR]
Detail Get the Remote Control inhabitation state
Response
Acceptable “%1” [CR]
%1
“000 OFF” = OFF : operable
“000 ON” = ON : inoperable
Unacceptable “?” [CR]