ScyTek Electronics 100RS - Manual (Page 8)

Valet Mode
The Valet Mode temporarily disables the remote start system so the vehicle may be serviced by a mechanic.
To activate or deactivate the Valet Mode:
1. Turn on the ignition.
2. Press and hold the override switch for 5 seconds.
· The parking lights will flash once to confirm the Valet Mode is on or twice to confirm Valet Mode
is off.
3. Turn off the ignition.
Remote Starting Manual Transmission Mode
Normal Mode:
With engine running and Handbrake engaged put the vehicle transmission in neutral and remove the foot
from the brake pedal, press remote start button on your transmitter, Parking lights will flash twice indicating
Manual Start Mode is enabled, turn Off the Ignition switch, the engine will remain running. Open and close
the door, the system will shut the engine Off.
Starter is now ready for remote start operation.
Starter Ready Mode is canceled any time the door is opened; hand brake is released or any
other error condition.
To Remote Start the System:
1. Be sure the system is not in Valet Mode.
2. Press and hold the Transmitter Button for more than 1-second.
· The parking lights will turn on.
· The engine will start and run for the duration of its programmed Run Time.*
· The heater or air conditioner will turn on (if turned on prior to exiting the vehicle).
*If the engine fails to start on the first attempt, it will repeat the starting procedure 2 more times. If the vehicle
fails to start after a total of 3 times the parking lights will flash 4 times and the doors will lock (if installed).
Turn on the ignition and press the brake pedal to disengage the remote start feature and drive the vehicle.
Page 4 - Astra 100RS
Remote Start Features
System Operation