ScyTek Electronics 100RS - Manual (Page 6)

Remote Transmitter Description
The Astra 100RS is supplied with two Remote Transmitters used to control system operations.
Button - Activates the Remote Start feature.
Adding/Replacing Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all desired
transmitters ready and follow the steps below.
Note: Up to four 1-way transmitters can be programmed to operate the system. Any previously stored
transmitter code will be erased if not programmed within the following sequence. Be sure to have all
exixting remotes for programming.
To program 1-way transmitter(s):
1. Turn the ignition key On, Off, On, Off, and back On.
· The parking lights will flash 3 times.
2. Press and hold the Override switch for 5 seconds.
· The parking lights will flash 5 times.
· The LED will illuminate.
3. Press Button on the first transmitter.
· The parking lights will flash once.
4. Press Button on the first transmitter again.
· The parking lights will flash twice to indicate it has learned the code.
5. Repeat steps 3 and 4 for each transmitter (up to 4).
6. Turn off the ignition key.
· The parking lights will flash 3 times.
Page 2 - Astra 100RS
Remote Transmitters