Sharp UX-340L - Manual (Page 44)

Setting Up and Using OpenLCR
42
The following table shows marks related to OpenLCR that may
appear in the display.
Mark Meaning
OpenLCR has been activated and is ready for use.
(Blinking)
OpenLCR cannot be used because the rate data has
been erased. Your fax will automatically call
OpenLCR within the next 24 hours to receive new
data, or you can download the data manually if you
need to use OpenLCR immediately. See
Downloading (receiving) the rate data manually on
page 39.
The rate data in the fax is no longer correct and the
fax cannot connect to OpenLCR to obtain new data.
See
What to do if “E” appears in the display on page
45.
OpenLCR has been temporarily turned off. See
Temporarily turning off OpenLCR below.
Rate data was not yet available when your fax called
OpenLCR. Your fax will automatically call OpenLCR
again when the rate data is available. Until that time,
long distance calls will be routed through your
primary carrier.
(Blinking)
Your fax will automatically call OpenLCR within the next
24 hours to learn when correct rate data will be
available.
Temporarily turning off OpenLCR
If needed, you can temporarily turn off OpenLCR.
♦
When you temporarily turn off OpenLCR, long distance and
international calls will not be routed by OpenLCR. However, the
fax machine will still call OpenLCR periodically to receive updated
rate data.
all-ux340L.book Page 42 Thursday, December 23, 1999 5:37 PM