Smeg SLB510.1 - Manual (Page 5)

Instructions for Use 7
Placing and Installation
If the floor is uneven, use the adjustable feet to level the machine.
•
Undo the nuts. Rotate the feet to level the machine (fig. 5).
•
Fix the nuts (fig. 5.1).
Maximum height of the washing machine is 850 mm.
IMPORTANT
The floor on which the machine stands should be dry, otherwise the
machine may slide during the spinning cycle.
Connection to the Water Supply
The elbow connection of the inlet hose is fixed to the coupling on the rear
wall of the appliance.
Insert a rubber washer with a net (filter) into a nut on the other end of
the hose, and fix the hose to a tap. To ensure efficient operation, the
water pressure of the water supply should be between 0.5 and 8.0
bars.
If the pressure exceeds the maximum allowed limit, fit a pressure
regulator. (Open the tap fully - in 15 seconds, 3 litres of water should
pour out; and this is the minimum pressure of the water supply).
Connection to cold water
Insert the enclosed washer with filter into the loose end of the hose and
connect the hose to water tap (fig. 6).
Connection to hot/cold water
Washing machines designed for the connection to hot/cold water are
equipped with two inlet hoses. The attachment and the inlet hose for hot
water are marked with red colour.
5.1 5