Shark V1950 - Manual (Page 6)

Fig. 4
Charging
Light
Indicator
Charging Instructions
1. Connect the charger plug to the charging jack or hole on the side of the sweeper.
Plug the charging adapter into the wall outlet. (120V., 60Hz.) Use only charger
Kuantech KA12D120015023U. (Fig. 4)
4
OPERATING INSTRUCTIONS
2. This cordless sweeper is powered by Ni-Cd batteries. Before first use, they must
be charged for a minimum 20 hours.
3. When recharging the unit, the "On/Off" switch must be in the "OFF" position.
4. The charging light indicator on the top of the sweeper will illuminate to indicate
that the sweeper is properly charging.
5. To recharge, repeat step #1 above. Charging times will vary depending upon the
amount of usage between charging cycles.
Note: If, when you place the sweeper to recharge and the charging indicator light does
NOT illuminate, then press the On/Off button once to turn the sweeper off. The
charging indicator light should now light up.
Note: Peak performance may only be realized after the unit has been charged and
discharged two (2) or three (3) times.
Important: To maintain peak performance of your cordless sweeper, it is
recommended that the unit be fully discharged, then completely re-charged at least
once a month.
Caution:
• Use only the adaptor supplied with the sweeper.
• Do not clean the sweeper while unit is charging.
• Do not attempt to remove the battery pack from the unit to charge it.
• Never attempt to throw the battery pack or unit into a fire or incinerate it.
• Do not attempt to remove or damage the battery casing.
Cambio del Cepillo Giratorio, Engranajes y Escobilla de Goma
1. Quite el tubo de extensión del cabezal eléctrico de la barredora.
2. De vuelta el cabezal eléctrico teniendo cuidado para no encenderlo
accidentalmente.
3. Quite la cubierta del cepillo.
4. Presione en la traba de los engranajes y levántelos para removerlos.
(Fig. 15 y Fig. 16)
Levante
Fig. 14
21
INSTRUCCIONES DE USO
Fig. 18
Fig. 17
Fig. 13
Traba Engranajes
Pestañas de
los engranajes
5. Levante el extremo del cepillo y el tope fuera de la ranura. (Fig. 17)
6. Separe el cepillo del cojinete y deslícelo por debajo de la correa para removerlo.
(Fig. 18)
7. Inserte el cepillo nuevo colocando primero el extremo opuesto al de la correa en el
cojinete. (Fig. 18)