Sharp AN-CM270 - Manual (Page 9)

PAGE 9
INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
FIGURE 11 DETAIL OF POSITIONING ASSEMBLY
CEILING PLATE
PLASTIC CEILING PLATE
TRIM COVER
LOCKING NUT AND HORIZONTAL POSITION ADJUSTMENT
HORIZONTAL TILT ADJUSTMENT
VERTICAL POSITION ADJUSTMENT
STEP 8 INSTALL THE PLASTIC TRIM COLLAR
8.1 The plastic trim collar may be used as a cosmetic concealment of the positioning adjustment knuckle
assembly and the audio and video signal cables.
8.2 The slit side of the collar enables the installer to spread the collar enough to place it over the adjustment
knuckle. It will curve back by its o wn spring action to wrap around itself enough to close the gap.
(See Fig. 12)
8.3 If the projector is hung at a sharp angle, you may trim the collar for a better fit. (See Fig. 13)
FIGURE 12 FIGURE 13
DO NOT RUN THE AC POWER CORD INSIDE THE PLASTIC TRIM COLLAR. ALL
WIRING MUST COMPLY WITH THE NEC AND ALL LOCAL BUILDING, ELECTRIC AND
SAFETY CODES.
NOTE: IN THE EVENT YOU WISH TO USE THE SHARP ADJUSTABLE EXTENSION
ACCESSORY IN CONJUNCTION WITH THE CEILING MOUNTING BRACKET, PLEASE
REFER TO THE INSTALLATION INSTRUCTION MANUAL INCLUDED IN THE
EXTENSION TUBE PACKAGE.