Sharp AN-CM270 - Manual (Page 3)

INSTALLATION INSTRUCTIONS CEILING BRACKET AN-CM270
PAGE 3
FIGURE 1. ILLUSTRATION OF PARTS FOR CEILING BRACKET
C.
D.
E.
I.
H.
INVERT THE PROJECTOR IMAGE
Please refer to the o wners manual for your LCD Projector for detailed instructions of ho w to electrically
invert the projected image to accommodate its use in the ceiling mounted mode.
LOCATION OF THE CEILING BRACKET
Please refer to the o wner’s manual for your SHARP LCD PROJECTOR for information which will help
you to determine the best location for the placement of the ceiling mounting bracket assembly.
INSTALLATION OF THE CEILING BRACKET
Af ter you have determined the appropriate location for the ceiling bracket, you must locate the exact
location of the ceiling beams. Most standard residential construction uses 16 inches bet ween centers
for overhead beams. You can mount the ceiling bracket by straddling t wo beams, or you can install the
bracket in line with a single beam.
CAUTION: THE BRACKET MOUNTING SCREWS MUST GO DIRECTLY INTO THE BEAMS.
SHEETROCK, LATH AND PLASTER, WILL NOT PROVIDE A SUFFICIENTLY SECURE
SUPPORT.
STEP 1. INSTALLATION OF THE METAL CEILING BRACKET
After the location for the ceiling bracket has been determined, (see LCD PROJECTOR
Owner’s Manual), make sure to locate beams in the ceiling.
B.
A.
F.
G.
K.
J.