Sherwood R-771 User Manual

Page 27

ENGLISH

Cancel the test tone function.

ENTER

CH.LEVEL

CHANNEL

ENTER

CH.LEVEL

CHANNEL

At each channel, adjust the level as
desired until the sound level of each
speaker is heard to be equally loud.

To cancel the surround mode for stereo operation

• Depending on the signal format which is being input, either the stereo

mode or the 2CH downmix mode is selected.

• To cancel either the stereo mode or the 2CH downmix mode, select

the surround mode with using the MULTI CONTROL knob on the
front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on
the remote control.

2CH downmix mode

• This mode allows the multi-channel signals encoded in DTS or Dolby Digital format to be mixed down into 2 front

channels and to be reproduced through only two front speakers or through headphones.

• When the SPEAKER button is set to off to listen with headphones, if the STEREO button is pressed while playing

the multi-channel digital signals from DTS or Dolby Digital sources, it will enter the 2CH downmix mode
automatically.

• To cancel the 2CH downmix mode, select the desired Dolby Headphone mode with using the MULTI CONTROL

knob on the front panel or the SURROUND MODE UP/DOWN ( >/< ) buttons on the remote control.

• The Dolby Headphone function simulates 5.1 channel surround sound, which allows you to enjoy 5.1 channel

surround sound through 2 channel headphones, just like listening from 5.1 channel speakers.

Notes :

• Only when the SPEAKER button is set to off, the Dolby Headphone mode can be selected.
• When playing the 96 kHz PCM(2 channel) digital signals, only the stereo mode can be selected.

• While listening with headphones, select the desired Dolby Headphone mode.

• Each time the MULTI CONTROL knob is rotated or the SURROUND

MODE UP/DOWN ( >/< ) buttons are pressed, the mode changes as
follows :

DH 1 : This simulates the soundfield as if you were in a relatively small room

with less reverberations.

DH 2 : This simulates the soundfield as if you were in a typical listening room

with moderate reverberations.

DH 3 : This simulates the soundfield as if you were in a large space like theater

Listening in a Dolby Headphone mode

ENTER

CH.LEVEL

CHANNEL

ENTER

CH.LEVEL

CHANNEL

Continued

Enter the test tone mode.

• The volume level of each channel can be adjusted easily with the test tone function.

Note : When the SPEAKER button is set to off or it is in the stereo mode, the test tone function does not

work.

Adjusting each channel level with test tone

• The test tone will be heard from the speaker of each

channel for 2 seconds as follows:

Front Left Center Front Right Surround Right

SL (

SB) or (

BR)

Subwoofer Surround Left Surround Back Surr.Back Left Surr.Back Right

• When the speaker setting is "NONE", the test tone of

the corresponding channel is not available.

• ( ) : Possible depending on whether the surround

back channel is set to "2 CH" or "1 CH".

ENTER

CH.LEVEL

CHANNEL