Sherwood R-771 - Manual (Page 21)

ENGLISH
20
Programming a macro function
Note:
You should press the corresponding DEVICE buttons
before pressing each operation button.
Example) When playing a DVD on the DVD player
connected to VIDEO 2 jacks of this receiver.
1. Press "AUD" button to control this receiver.
2. Press "POWER ON" button to turn this receiver
on.
3. Press "AUD" button to control this receiver.
4. Press "VIDEO 2(7)" button to select the desired
input source.
5. Press "DVD" button to control the DVD player.
6. Press "POWER ON" button to turn the DVD player
on.
7. Press "DVD" button to control the DVD player.
8. Press "
" button to start playback.
Press the operation buttons you want to
program in order.
2
Press and hold down both "ENTER"
button and one of three NUMERIC
buttons ("1"~"3") corresponding to
"M1"~"M3" buttons for more than 1
second.
1
• If the programming is performed successfully, the
LED will flicker twice.
To remove a macro program
• When removing a macro program, perform the
above steps and , but ignore the step .
To change a macro program
• When a new macro program is stored into a
MACRO button with performing the above steps
to , the previous macro program is cleared
from the memory of the MACRO button.
Press "ENTER" button.
3
• The macro function enables you to program a
series of button operations(up to 10) on this
remote control into a single button.
• You can store up to three separate macro
command sequences into "M1", "M2" and "M3"
buttons.
Operating a macro function
Notes:
• The codes programmed into a MACRO button
will be transmitted at an interval of 0.5 seconds.
However, some components may not be able to
complete one operation in 0.5 seconds and
may miss the next code.
In this case, the macro function cannot control
the corresponding components correctly.
• Be sure to use the remote control within the
remote control operation range of the
components.
• Depending on the operation status of the
components, etc., the macro function cannot
control the corresponding components
correctly.
• Aim the remote control at the REMOTE SENSORs
of the components to be controlled and press the
MACRO button you want.
Example) When pressing "M1" button.
• If the macro mode is entered, the LED will flicker
once.
Example) When programming a series of button
operations into "M1" button.
ENTER ENTER
CH.LEVEL CH.LEVEL
CHANNEL CHANNEL
ENTER ENTER
CH.LEVEL CH.LEVEL
CHANNEL CHANNEL