SmartPool Inc Underwater Lighting System NL50 - Manual (Page 3)

INSTALLATION
A.
Remove top cap of pool vertical post nearest your installation.
B.
Lift one end of your poolʼs top ledge. The top ledge is comprised of flat sections that extend
around the top of the pool wall.
C.
Slide the pool light onto the pool wall submerging the light in the water. Locate the light in the
middle of the top rail to allow for easier installation.
D.
Hold the light down so that the top of the mounting bracket is flush with the top of pool wall. Turn
thumbwheel in a clockwise direction to tighten securely to the wall.
E.
Be sure that wire runs completely through the channel of the mounting bracket.
F.
Replace top rail and cap.
G.
Make sure that water level is above the minimum water line on the light. If not add water to pool.
H.
The transformer should be mounted on a nearby vertical surface using the screws provided.
Mount the transformer a minimum of 18 inches from the ground.
I.
Plug unit only into a GFCI 110V socket. DO NOT USE EXTENSION CORDS.
OPERATION
Plug light into GFI protected outlet. Push switch on power supply to turn on. This light has a built in timer
that will automatically turn the light off 3 hours after the light has been turned on. When turning the light
on again, simply push the color selector switch (Fig 7) to “wake it up”!
CHANGING COLORS
CHOOSING A SINGLE COLOR
This multi-colored light has either a constant color selection, or automatic
color rotation. To select a color, simply press the color selector switch lo-
cated near the thumbwheel (FIG 7) on the mounting bracket of the light.
Each time you press the button the light will switch to a new color. Stop
pushing the button when desired color is reached.
AUTOMATIC COLOR ROTATION
To have a continuous and automatic rotation of the light colors, simply
press and hold the color selection switch for 3 seconds. This will put the
unit into automatic mode, and the unit will cycle through all of its colors in roughly 10 second intervals.
To exit the automatic mode, simply press and hold the color selector switch for 3 seconds. Your light is
now in single color mode.
2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 3