SmartPool Inc Underwater Lighting System NL50 User Manual

Page 2

Use a Phillips head screwdriver to remove the three screws

retaining the heat diffuser/heat shield. (See Fig 3) Place the

screws in an area where they will not be lost. Carefully re-

move the round

diffuser/heat shield.

Remove one of the three colored bulbs from its box being

careful not to touch the face of the bulb. Place the legs of the

bulb into one of the three ceramic outlets as shown in Figure

3. Repeat for the other two bulbs. NOTE: It does not matter

which bulb goes where.

Remove the bulb from its box being careful not to touch the

lens of the bulb. Install the bulb by pressing the two bronze

legs of the bulb into the ceramic socket in the light housing as

shown in FIG. 4. Repeat for the other two bulbs and sockets.

Be sure that the bulbs are firmly pressed into the socket.

BE CAREFUL NOT TO BURN YOURSELF, AS THE BULBS

GET HOT QUICKLY AND SHOULD BE TURNED OFF IMMEDI-

ATELY UPON SUCESSFUL TEST. OPERATION OF THIS FIX-

TURE OUT OF WATER FOR ANY PROLONGED TIME WILL

DAMAGE UNIT AND VOID WARRANTY.

Plug the light into wall outlet. Turn switch on. If light comes on,

press color selector switch (FIG 6) and be sure all bulbs are

working, if so test successful. Unplug the unit. Move to step G.

If light does not turn on, unplug unit from wall and reinstall light

bulb. Repeat test again, if still not working call Smartpool cus-

tomer service at 732- 730-9880.

. Carefully install the round diffuser/heat shield into the light box as

shown in figure 5. Be sure that the glass has its textured (rough)

side facing away from the bulb. Reinstall all three screws

Carefully replace the lens making sure that there is an even flat

fit in the light body.

Place the seal ring carefully over the lens making sure it is on

straight. Now turn in a clockwise direction until the ring begins

to tighten up. You may hear a clicking sound which is normal.

This is a safety feature designed to not allow the light seal to

loosen up or be removed without the key.

Continue to turn clockwise until the index mark on the seal ring

is even with the light body as shown in Figure 4. NOTE DO

NOT OVERTIGHTEN OR TURN BACK SEAL RING IN A

COUNTER CLOCKWISE FASHION AS THIS WILL CAUSE

LEAKAGE!

Light is ready to install.

2007 NLMC Manual:Layout 1 1/17/07 11:43 AM Page 2