Sony TA-VE800G - Manual (Page 16)

16 GB
Preparing and Using the Remote
Registering Audio/Video
Equipment
Registering Sony audio/video equipment
If your Sony audio and video equipment can be
controlled by an infrared remote, simply connect them
to the jacks shown on the following table, registration
is unnecessary.
Amplifier jacks Equipment to be connected
VIDEO 1 Sony VTR 3 (VHS)
VIDEO 2 Sony VTR 1 (BETA)
VIDEO 3 Sony VTR 2 (8 mm)
LD Sony LD player
SATL Sony Satellite decoder
TUNER Sony Tuner
DAT/MD Sony DAT deck
CD Sony CD player (CD 1)
TAPE Sony Tape deck
MONITOR Sony TV
The following cases require registration of Sony products
• When connecting a Sony MD deck to the DAT/MD
jacks.
• When connecting a Sony audio product with
CONTROL-A1 compatibility.
• When connecting a Sony product to jacks other than
those specified in the previous table (e.g., when
connecting a Sony LD player to the VIDEO 3 jacks).
• When exchanging non-Sony audio or video
equipment with a Sony product.
Notes
• If your VCR has a COMMAND CODE selector switch (for
VTR1, VTR2, or VTR3), set the switch to the applicable
setting.
• If your CD changer has a COMMAND MODE selector
switch (for CD 1, CD 2, or CD 3), normally it should be set
to “CD 1”. However, if your CD changer has VIDEO OUT
terminals, set the command mode to “CD 2” or “CD 3”
(“CD 3” should only be used when making CONTROL-A1
connections).
Registering non-Sony audio/video
equipment
If you connect audio or video equipment made by
another manufacturer, you must programme the IR
codes used by the equipment before you can control it
through the amplifier.
You can programme up to 120 IR codes, including user
IR codes; however, depending on the type of codes
recorded, the maximum limit may be less than 100. It
may be difficult or impossible to programme up to 120
codes under the following conditions:
• When programming IR codes of special remotes such
as card type remotes, or remotes for household
appliances such as air conditioners.
• When programming from remotes with weak
batteries.
• When programming IR codes that have been
programmed to a programmable remote (i.e., any IR
code not originally supplied in the respective remote).
Registration
1
Click FUNCTION in the main menu.
2
Click IR SET.
3
Click the appropriate function.
FUNCTION SELECT
VIDEO 1 DAT/MD
CD VIDEO 2
TUNER VIDEO 3
PHONO L D
TAPE SATL
MACRO 1 MACRO 2
EXIT
IR SET
FUNCTION
+
–
VOL
ALL
OFF
USER SUB
S
O
U
N
D
) ( 0 p P = +
EXIT
VIDEO 1 Sony VTR3
Sony VTR1
Sony VTR2
SATL
DAT/MD Sony DAT
CD Sony CD1
TAPE Sony TAPE
Sony DBS
Sony LD
IR CODE SETTING
VIDEO 2
VIDEO 3
LD
RETURN
TUNER Sony TUNER