Sharp CD-BA120 - Manual (Page 15)

HK
TIMER/
SLEEP
Timer set indicator POWER
ON/
STAND-BY
MEMORY/
SET
TUNING/
TIME
( )
CD
TUNER
(BAND)
TAPE
(1 2)
HOW TO USE THE BUILT-IN TIMER
3
4
5
■
Timer recording
1
Press the ON/STAND-BY button to turn the power on.
● Load a cassette for recording into the TAPE 2 cassette com-
partment.
2
Press the TUNER (BAND) button to select the desired fre-
quency band.
3
Press the TIMER/SLEEP button repeatedly until " f " and
"REC" are displayed.
● The timer set indicator will flash.
4
Press the TUNING/TIME ( X or W ) button to set the hour start
time, then press the MEMORY/SET button.
5
Press the TUNING/TIME ( X or W ) button to set the minute
start time, then press the MEMORY/SET button.
● The power will be automatically turned off, and the timer set
indicator will light up.
6
When the preset time is reached, the timer recording will start.
● The volume will increase gradually until it reaches the volume
you were listening to before turning off the unit.
7
When the recording tape reaches its end, the timer recording
will end, and the power will be turned off.
To cancel timer operation:
Press the ON/STAND-BY button to turn the power on.
To change the programmed contents:
Start again from step 1.
Note:
● Once the time is set, the setting will be retained until a new
time is entered.
■
Sleep operation
The radio, compact disc and cassette deck can all be turned off
automatically.
1
Play back the desired sound source.
2
Press the TIMER/SLEEP button repeatedly until "SLEEP" is
displayed.
To change the sleep time:
While the sleep time is displayed, press the TUNING/TIME ( X
or W ) button to adjust the time.
(Maximum: 3 hours - Minimum: 1 minute)
The amount of sleep time can also be changed during the sleep
operation.
● 3 hours - 5 minutes
→
5-minute intervals
● 5 minutes - 1 minute → 1-minute intervals
3
Press the MEMORY/SET button.
4
The unit will turn off automatically after the preset sleep time
has elapsed.
Note:
● Once the sleep time is set, it will remain the same duration
until the setting is changed.
To confirm the remaining sleep time:
Press the TIMER/SLEEP button.
To cancel the sleep operation:
Press the ON/STAND-BY button to enter the stand-by mode.
■ Timer playback
1
Press the ON/STAND-BY button to turn the power
on.
2
Press the CD, TUNER (BAND) or TAPE (1 V 2)
button to select the desired function.
3
Press the TIMER/SLEEP button repeatedly until " f "
is displayed.
● The timer set indicator will flash.
4
Press the TUNING/TIME ( X or W ) button to set the
hour start time, then press the MEMORY/SET but-
ton.
5
Press the TUNING/TIME ( X or W ) button to set the
minute start time, then press the MEMORY/SET but-
ton.
● The power will be automatically turned off, and the
timer set indicator will light up.
6
When the preset time is reached, the volume will
increase gradually until it reaches the volume you
were listening to before turning off the unit.
7
If you select CD or TAPE during timer playback, the
power will be turned off after the tape or CD is
finished playing back.
If you select TUNER (BAND), the power will be
turned off one hour later.
● Before setting the timer, make sure that the clock
setting is correct. (Page 6)
(Main unit operation)
CD-BA120(SEC) TINSE0299AWZZ
14