Sony TC-WR661 - Manual (Page 4)

3-810-312-31(1)
4 EN
Getting Started
Unpacking
Check that you received the following items:
• Audio connecting cords (2)
Hooking Up the System
This section describes how to hook up the tape deck to
an amplifier. Be sure to turn off the power of each
component before making the connections.
To purchasers of the TC-WR661
For information on connecting your tape deck to the TA-
AV561 Amplifier, refer to the Operating Instructions
included with the TA-AV561.
To purchasers of the TC-WE405
Follow the instructions below to connect your tape deck to
an amplifier.
Getting Started
Hookups
When connecting an audio connecting cord, be sure to
match the color-coded cord to the appropriate jacks on
the components: Red (right) to Red and White (left) to
White. Be sure to make connections firmly to avoid
hum and noise.
Connect the tape deck to the amplifier as shown below.
Tape deck Amplifier
ç : Signal flow
З
з
REC OUT IN
LINE
OUT IN
L
R
TAPE
L
R
L
R
Setting the voltage selector (only on
models supplied with a voltage selector)
Check that the voltage selector on the rear panel of the
tape deck is set to the local power line voltage. If not,
set the selector to the correct position using a
screwdriver before connecting the AC power cord to
an AC outlet.
Amplifier
to a
wall outlet
to an AC
outlet
to LINE OUT
to TAPE IN to REC OUT
to LINE IN
TC-WE405
2 2 0 V
2 4 0 V
1 2 0 V
V O L T A G E
Connecting the AC power cord
Connect the AC power cord to an AC outlet.
Where do I go next?
Now you’re ready to use your tape deck.
For basic operations, go to pages 5 to 7; for advanced
operations, go to the sections starting from page 8.