Shindaiwa EB633RT - Manual (Page 12)

12
Eng
lish
sTarTInG Warm enGIne
Throttle Lever/Stop Switch
Move throttle lever (A) forward to idle position. Slide stop switch (B)
forward to run position.
Recoil Starter
Pull recoil starter handle (E) and engine should start. Do not use choke (C).
NOTE
If engine does not start after 5 pulls, use cold start procedures.
1.
2.
sToppInG enGIne
Throttle Trigger/Throttle Position Lever
Release throttle trigger (C). Move throttle position lever (A) forward to
idle position and allow engine to return to idle before shutting engine off.
Stop Switch
Slide stop switch (B) to Stop position.
WARNING
If engine does not stop when stop switch is moved to STOP position,
close choke - COLD START position - to stall engine. Have your
Shindaiwa dealer repair stop switch before using blower again.
1.
2.
b
A
b
A
C
C
E