Sim2 Multimedia GRAND CINEMA HT HT5000 - Manual (Page 9)

9
ht5000
Fig. a
Position the projector on a stable, suitable platform or utilise the
optional bracket for a fixed ceiling installation.
wARNiNg: if using the ceiling mount bracket, scrupulously
observe the safety instructions included with the bracket
itself. if using a bracket other than that supplied by SiM2
Multimedia, make sure that the projector is at least 65 mm
below the ceiling and that the bracket does not obstruct the
air vents (intake and outlet).
If the projected image is not level, adjust the feet on its base
to obtain a level position, lining up the base of the projected
image to the base of the projection screen (Fig. ).
Place the projector at the desired distance from the screen:
the size of the projected image is a function of the distance
between the lens and the screen and the lens zoom setting.
Use the motor zoom (Fig. ) to zoom the projected image in
and out.
Use the motor focus function (Fig. ) to obtain a clear image;
if the image is correctly focused, you should be able to see
each single pixel of the projected image when close to the
screen (Fig. ).
ZOOM
ZOOM
ZOOM
ZOOM
F1
FOCUS AUTO ASPECT VCR
HELP ZOOM
F2
ZOOM
FOCUS
FOCUS
FOCUS
FOCUS
The motorized lens shift adjustment allows the projected image
to be moved vertically and horizontally (left or right)
The maximum adjustment is equal to half the height of the
image in either direction (Fig.a).
If this displacement is insufficient, tilt the projector and correct
the keystone error with the Keystone adjustment in the SETUP
menu (Fig. 4).
4 iNSTALLATiON
Fig.
Fig.