SIIG 04-0629A - Manual (Page 4)

4
Driver Installation
This section provides information on how to install the
2S1P Combo-Value drivers. Please make sure the board is
installed before proceeding.
Windows 7 (32-/64-bit)
1. Install the board and boot up Windows.
2. Right click Computer, click Manage, click Device
Manager.
3. Insert the driver CD. Right click PCI Parallel Port,
click Update Driver Software.
4. Click Browse my computer for driver software.
For 32-bit: Type D:\32bit, then click Next. (Change
D: to match your CD-ROM drive letter)
For 64-bit: Type D:\64bit, then click Next. (Change
D: to match your CD-ROM drive letter)
5. At Windows has successfully updated your driver
software, click Close.
6. Right click PCI Serial Port, click Update Driver
Software.
7. Repeat steps 4-5.
8. Right click PCI Serial Port, click Update Driver
Software.
9. Repeat steps 4-5 to complete the installation.
Windows Vista (32-/64-bit)
1. Install the board and boot up Windows.
2. Insert the driver CD. At the Found New Hardware
window, insert the driver CD, click Locate and
install driver software (recommended), then click
Continue.