Sony TA-FE910R - Manual (Page 8)

Basic Operations
8 EN
EON LINK
PROTECTION
PHONES
SPEAKERS
A
BASS
• OFF
A + B
– 10 + 10
TREBLE TONE
•
– 10 + 10
BALANCE
LOUDNESS TAPE MONITOR Ø ON ø OFF
SUBSONIC
PHONO TUNER CD AUX TAPE2/MD TAPE1/DAT
INPUT SELECTOR VOLUME
SOURCE DIRECT EON LINK
0 10
Ø ON ø OFF
•
LEFT RIGHT
B
g
POWER
SOURCE TAPE1 TAPE2
To receive the Enhanced Other Networks (EON) programmes (TA-
FE910R/FE710R/FE610R/FE510R only)
When your ampifier is connected to a Sony tuner with the EON CONTROL
system, the amplifier switches to any EON programme that is broadcast in
your EON area, and switches back to the last selected programme source
when the programme ends.
z
What is the Enhanced
Other Networks (EON)?
One convenient RDS service
is ”Enhanced Other
Networks” (or ”EON”).
This allows the unit to
automatically switch to a
programme type of your
choice when one starts in
your broadcast area.
1
Make sure that the amplifier and the tuner are connected through the
EON CONTROL terminals (see page 5).
2
Press EON LINK so that the indicator lights up.
Whenever an EON programme starts on the radio frequency that your
tuner is set to, you will receive it.
To cancel EON reception
Press EON LINK again so that the indicator goes off.
Notes
•If you select another programme source while receiving an EON programme, EON
reception ends. However, as long as the EON LINK indicator lights up, you can
receive EON programmes automatically.
•Make sure to cancel EON reception before starting to record since an EON
programme may interfere with your recording.
•If you activate the Tape Monitor function (see page 9) while the EON LINK indicator
is lit, the indicator goes off and you cannot receive EON programmes. If this
happens, deactivate the Tape Monitor function so that the indicator lights up again.