Sun Microsystems STOREDGE FC-100 - Manual (Page 28)

2-6 Sun StorEdge FC-100 Hub Installation and Service Manual • September 1998
■ To insert a GBIC that has a bail, slide the GBIC into the available port with the
bail in the unlocked (right) position. Once the GBIC is firmly seated in the port,
move the bail left into the locked position.
FIGURE 2-4 Installing a GBIC That Has a Bail and Fiber Optic Cable
3. Connect the fiber optic cable to the GBIC.
Fiber optic cable connectors are keyed to prevent improper insertion; they can only
be installed as shown in
FIGURE 2-3 and FIGURE 2-4 .
4. Route the fiber optic cable to an initiator or target.
Refer to the documentation that came with the device.
5. Connect the fiber optic cable to a GBIC in the initiator or target.
Refer to the documentation that came with the device.
2.3.6 Routing the Power Cord
If you are installing the hub along with Sun StorEdge A5000 Disk Arrays in a Sun
StorEdge Expansion Cabinet, refer to the Sun StorEdge A5000 Disk Array Hardware
Configuration Guide, part number 805-0264-12 (or later), for cable routing.
Notches
Slot
Key (on side)
Bail