Sun Microsystems STOREDGE FC-100 - Manual (Page 25)

Chapter 2 Installation 2-3
2. Install the tray in the cabinet ( FIGURE 2-1 ).
FIGURE 2-1 Installing the Tray in the Cabinet
Caution – Use only SAE 10-32 screws to secure the tray to the cabinet mounting
rails. Using any other screw type will damage the cabinet mounting holes.
a. In the front of the tray, use the Phillips screwdriver to loosely install two 10-32
screws each for the left and right side.
b. In the back of the tray, use the Phillips screwdriver to loosely install two 10-32
screws each for the left and right side.
c. Tighten both sets of screws.
Front
Rear
!