beautypg.com

Operation – Sears 486.248463 User Manual

Page 15

background image

15

OPERATION

KNOW YOUR SNOW THROWER

Read this owner's manual and safety rules before operating your snow thrower.

Compare the illustration below with your snow thrower to familiarize yourself with the various controls and their locations.

CHUTE TILT HANDLE Pivots the Upper Chute up or

down to control the angle and distance of dis charge.

CRANK ROD Rotates the Lower and Upper Chutes to

control the direction of discharge.

LEVELING SHOE Helps maintain the snow thrower in a

level position.

LIFT HANDLE Used to lift or lower the snow thrower

to transport or op er at ing position.

LIFT RELEASE TRIGGER Releases the lock which

holds the snow thrower in the up, transport position.

UPPER AND LOWER DISCHARGE CHUTE Controls

direction and height of snow discharge.

SCRAPER PLATE Replaceable plate that absorbs

wear and impact from contact with ground.

SKID SHOE Controls amount of clearance between

the scraper plate and the ground.

SPIRAL AUGER, R.H. & L.H. Feed snow to the

impeller fan at the center of the housing.

HOW TO START YOUR SNOW THROWER

The tractor should be sitting with the engine run ning
at full throttle. Pull the at tach ment clutch switch out to
the en gaged position, starting the snow thrower before
starting the tractor in motion.

HOW TO STOP YOUR SNOW THROWER

• To stop the snow thrower, push in the attachment

clutch switch on the tractor. Refer to the Operation
section in your tractor owner's manual.

BEFORE STARTING

• Use the end of assembly checklist to verify that all

instructions have been properly completed.

• Make sure the skid shoes are adjusted to maintain

adequate ground clearance between the snow
thrower and the type of surface to be cleared. The
skid shoes are factory adjusted for clearing a smooth
surface. (Refer to the Service and Ad just ments
section in this manual.)

• Make sure the tractor engine has the correct oil for

winter operation. Refer to your tractor owner's man u al.

LIFT HANDLE

LIFT RELEASE TRIGGER

CRANK ROD

CHUTE TILT HANDLE

UPPER CHUTE

LOWER CHUTE

SPIRAL AUGERS, R.H. & L.H.

SKID SHOE

SCRAPER PLATE

LEVELING SHOE (Behind housing)