SIIG 133 - Manual (Page 9)

9
4. Select SIIG CN2487 UDMA133 IDE WinXP Miniport Driver
and press Enter.
5. Press Enter to continue and follow on-screen instructions to
complete Windows XP installation.
Note: When the Software Installation warning pops up, click
Yes . And when the Hardware Installation warning pops up,
click Yes again.
For Existing Windows XP Systems
1. Boot up Windows XP.
2. At the Found New Hardware Wizard, check Install from a
list or specific location(advanced) , then click Next.
3. Insert the Driver diskette. Check Include this location in the
search , uncheck the other box, type in A:\winXP, and click
Next .
4. When a warning message pops up, click Continue Anyway,
then click Finish.
5. Remove the Driver diskette and click Yes to restart Windows.
Verify Proper Installation for Windows 2000/XP
1. Double click My Computer/Control Panel/System.
2. Click Hardware then click Device Manager.
3. Double click SCSI and RAID Controllers, then double click
SIIG CN2487 UDMA133 IDE Adapter to display driver
properties.
4. A message This device is working properly is displayed in the
dialog box, the driver has been correctly installed.
Bios Configuration
The UltraATA 133 PCI BIOS will appear everytime your system
starts up. If the bios doesn't show, please try your controller in
another PCI slot. During this (Post) process, the bios will show up
and indicate the devices attached to it.