SIIG 133 - Manual (Page 7)

7
3. Highlight SIIG CN2487 UDMA133 IDE Controller and click
Properties . A message This device is working properly is
displayed in the dialog box, the driver has been correctly
installed. If any error message is displayed, remove SIIG
CN2487 UDMA133 IDE Controller
and restart your system.
Windows NT 4.0 Driver Installation
For New Windows NT 4.0 System
1. Follow Microsoft procedures to install Windows NT 4.0
accordingly.
2. At the Windows Set-up screen, press F6 to specify and add
the driver.
3. Press S, select Other, then press Enter.
4. Insert the Driver diskette and press Enter.
5. Select SIIG CN2487 UDMA133 IDE NT miniport Driver and
press Enter.
6. Press Enter to continue and follow on-screen instructions to
complete Windows NT 4.0 installation.
For Existing Windows NT 4.0 System
1. After installing the board, boot up Windows NT. Double click
My Computer /Control Panel/SCSI Adapters, then click the
Drivers tab.
2. Click Add… then Have Disk....
3. Insert the Driver diskette into the floppy drive and type in
A:\Winnt , then click OK.
4. Highlight SIIG CN2487 UDMA133 IDE Adapter and click
OK .
5. Remove the Driver diskette and click Yes to restart Windows.
Verify Proper Installation for Windows NT 4.0
1. Double click My Computer/Control Panel/SCSI Adapters.
2. Highlight SIIG CN2487 UDMA133 IDE Adapter from SCSI
Adapters listing and click Properties. A message This device is
working properly is displayed in the dialog box, the driver has
been correctly installed.