Smeg 155620 User Manual

Page 7

155620

• Fix the outlet hose to run into the sink or the bathtub, or

connect it directly to the wall drain outlet (diameter min. 4 cm).

• Wall drain must be installed properly and must enable

occasional cleaning.

• Fasten the outlet hose support with a piece of rope led through

the hose elbow, to prevent the hose from slipping to the fl oor.

The end of outlet hose should be placed between minimum 60

cm and maximum 100 cm above the fl oor level.

• Plug the mains power cable to the wall mains socket.
• Required voltage and other information are written on the

rating plate above the door opening of the machine.

The wall socket must be accessible at all times and must

be equipped with an earth lead (in accordance with the
local safety regulations).

The permanent connection must be fi tted by an

authorized personnel only.

Damaged mains power cable may be replaced only by the

producer or his authorized personnel.

Never plug the appliance into the electric shaver socket

or hair dryer socket.

If the socket, the machine is connected to, is protected by
the overload protection switch (FID), the nominal differential
current of the switch must be 30 mA (switch mark Idn or
I∆n). In case of a smaller nominal current in the switch, the
machine may be switched off during its normal operation.

Water outlet connection

Connect the appliance to
the mains supply