Smeg 155620 - Manual (Page 6)

155620
• If you have a tumble dryer of the same dimensions, you can
place it on top of the washing machine.
To ensure correct operation of the appliance, water
pressure inlet must be between 0,05 and 0,8 MPa.
Minimum water pressure can be established by measuring
the quantity of poured out water. 3 litres of water must be
poured out from completely opened tap in 15 seconds.
• Insert the gasket with screen into the water inlet hose thread
Screw the hose thread to the water faucet
• In case of hot and cold water connection, connect one hose to
cold and other to hot water faucet as marked at the rear of the
appliance (letters C and H) (C - cold; H - hot)
Partial Aqua-stop (water stop system)
In case of damage on the interior pipe, leaking is prevented by
automatic closing system which stops water inlet to the machine.
In such cases display A turns red.
Inlet pipe must be replaced.
Complete Aqua-stop (certain models only)
In case of damage on the interior pipe, leaking is prevented by
automatic closing system which stops water inlet to the machine.
Security system also detects whether there is any water leakage
within the interior of the machine. In such cases washing is
suspended, machine switches on the pump and signals error.
Do not immerse the Aqua-stop system inlet pipe into
the water, because it contains the electric valve!
Water inlet connection Water inlet connection
6