Smeg 155620 - Manual (Page 18)

155620
After certain time you may open the door if the water level in the
drum is low enough, otherwise you must fi st empty the water
(use additional program Pumping water out
or Spin .
MA (models with the door opening by pressing the G knob
feature the function which enables you to open the door of
the appliance during power failure using special lever, located
adjacent to the fi lter.
• Setting the time of day
- Press MENU (B) and QUICK knobs (D), and turn the program
selector (A) to the fi rst clockwise program. Display reads
CLOCK and =00:00 (hh:mm) in the right corner.
- Hours start fl ashing; push the SELECTION knob (C) to set the
time of day.
- Confi rm setting by pushing the MENU knob (B).
- Now minutes start fl ashing; they are set the same way as
hours.
- Confi rm setting by pushing the MENU knob (B).
- Return the program selector back to “0” position. Set time is
automatically saved.
• Setting the Clean water sensor
In order for the Clean water sensor
to start working
properly, it must be fi rst calibrated with water that the washing
machine is connected to. This is performed in the following
manner:
- Press MENU (B) and Easy ironing knobs (E), and turn the
program selector to the fi rst clockwise program. Display
reads SENSOR CALIBRATION.
- Start calibration by pushing the START knob (F). The
machine performs calibration procedure automatically.
During the process the reading SENSOR CALIBRATION
is fl ashing. When the procedure is completed, the display
reads END.
- Return the program selector (A) back to “0” position.
If you change the inlet water source during the use of your
washing machine, or in case you think that water quality has
changed, you may repeat the calibration procedure at any
time. The machine will save the value of the last calibration.
Special functions
(certain models only)
Special functions
(certain models only)
18