Woodstock W1685 - Manual (Page 13)

-13-
SETUP
W1666, W1685 Dust Collectors
Figure 9. Caster installation.
Casters and Motor
To install the casters and motor/impeller assembly, do
these steps:
1. MAKE SURE THE DUST COLLECTOR MOTOR IS
UNPLUGGED!
2. Install the four swivel casters to the base plate
with the sixteen M6-1 X 12 Phillip head screws,
washers, and nuts (see Figure 9).
3. Bolt the motor to the motor mount with the four
M8-1.25 X 25 hex bolts, washers, and nuts; and
with lifting assistance, position the motor/impeller
assembly on the base (see Figure 10).
4. Secure the motor/impeller assembly to the base
using six M8-1.25 X 16 hex bolts, washers, and nuts
(see Figure 11).
For quiet and vibration-free operation, assemble your
dust collector as outlined below. DO NOT modify this
dust collector for any other purpose than what it is
designed for.
Figure 11. Motor/impeller assembly
installation.
Round
and
Rectangle
Support
Mounting
Flanges
Figure 10. Motor/impeller assembly posi-
tioning.
GET assistance when lifting machine parts. The
SHOP FOX ® Model W1666 and W1685 dust collector
motor/impeller assembly is heavy, and ignoring this
warning can cause you a severe back injury.
Motor
Mount