SpectraLink Link 150 M3 MCU - Manual (Page 4)

SpectraLink Corporation Installation and Operation
Link WTS – Link 150 M3 MCU
Table of Contents
1. About This Document 6
1.1 SpectraLink Corporation Model Numbers 6
1.2 Related Documents 6
1.3 Customer Support Hotline 6
1.4 Icons and Conventions 6
2. Installation Overview 7
2.1 Installation Steps and Responsibilities 8
3. Link Wireless Telephone System Overview 9
3.1 System Operation 9
3.2 The Front Panel of the Link 150 M3 MCU 11
4. Site Preparation 12
4.1 Required Materials 12
4.2 Determine Location of MCU 12
5. Run Cable for System 13
5.1 Run Cables to Base Station Locations 13
5.2 Pull Cable 13
5.3 Terminate Cable at Base Station Locations 14
5.4 Prepare Demarc Blocks 15
5.5 Install Demarc Blocks 18
5.6 Assign and Program Ports 18
5.7 Connect Cables from Base Stations and Phone Lines to Demarc Blocks 19
6. Install Link Wireless Telephone System 23
6.1 Survey Site 23
6.2 Check Components 23
6.3 Install MCUs 24
6.4 Install Base Stations 28
6.5 Install Outdoor Base Stations 30
7. Connect and Register Handsets 31
7.1 Set Up Diagnostic Modem 31
7.2 Register Handsets 31
7.3 Unregister Handsets 32
7.4 Program Handset Features 32
7.5 Test Handsets 33
8. Site Certification 34
9. System Administration 35
9.1 Troubleshoot Error Codes 35
9.2 Troubleshoot Handset Features 35
9.3 Status LED Codes 36
9.4 Replace a Handset 39
9.5 Replace an MCU 40
9.6 Replace a Base Station 41
10. Link Wireless Telephone Planning Worksheet 42
11. Base Station Location Worksheet 43
PN: 72-0075-01-F.doc Page 4