Sanyo EM-S5002W - Manual (Page 9)

9
INSTALLATION
Remove all packing material and accessories. Examine the oven for any
damage such as dents or broken door. Do not install if oven is damaged.
NOTE: This unit is not designed for 50 Hz or any circuit other than a
120-volt/ 60-Hz AC circuit. This oven is designed for countertop installation.
Countertop Installation
1. Select a level surface that
provides enough open space for
the intake and/or outlet vents.
A minimum clearance of 3 inches is
required between the oven and any
adjacent wall. One side must be open.
• Leave a minimum clearance of
3 inches above the oven.
• Do not remove the legs from
the bottom of the oven.
• Blocking the intake and/or
outlet openings can damage
the oven.
• Place the oven as far away
from radios and TV’s as possible.
Operation of microwave oven
may cause interference to your
radio or TV.
• If the cabinet is covered with a
protective film, remove the film.
2. Plug your oven into a standard
120-volt / 60-Hz household
outlet. Be sure the electrical
circuit is at least 15 amperes
and that your microwave oven
is the only appliance on
the circuit.
WARNING: Do not install oven
over a range cooktop or other
heat-producing appliance. If
installed near or over a heat source,
the oven could be damaged and the
warranty would be void.
SET UP