SV Sound SX-VT - Manual (Page 29)

SX-ST / SX-SV User Manual page 29
Mic/Line inputs
Input type: electronically balanced
Input impedance: 6.8k Ω , linear from 10 Hz to 200 kHz
RF filters: standard
Microphone power:
+48V (phantom power)
GAIN
: 60dB 48dB 36dB 24dB 12dB 0dB
Nominal level: -54dBu -42dBu -30dBu -18dBu - 6dBu + 6dBu
Maximum input level: -30dBu -18dBu -6dBu +6dBu +18dBu +25dBu
THD* ( Fader version) :
THD* ( VCA version) :
CMRR* @ 1kHz: >100dB >100dB >100dB >90dB >65dB >60dB
CMRR* 22Hz - 22kHz: >100dB >100dB >100dB >90dB >65dB >60dB
Noise LIN 22Hz - 22kHz: -68dBu -79.8dBu -90.4dBu -96.9dBu -98.5dBu -100.3dBu
Equivalent Input noise : -128dB -127.8dB -126.4dB -120.9dB -110.5dB -100.3dB
* 20 Hz to 22 kHz, at maximum input level
** Equivalent input noise from a 150
Ω source
Low frequency Filter (LF Cut) :
18dB/octave, 15Hz to 400Hz
Low frequencies Equaliser : 4 dB/octave, ±12dB at 80 Hz, ±15dB at 40 Hz??
High frequencies Equaliser : 4 dB/octave, ±12dB at 8 kHz, ±15dB at 16 kHz ??
Mid sweep Equaliser : 6 dB/octave, ±11dB 200 Hz to 8 kHz
Direct Output Level:
internally selectable Pre EQ, Pre Fade or Post Fader
+6dBu or +4dBu depending on global nominal level setting
electronically balanced, output impedance <50•
typical output noise if Pre-Eq selected -130dBu
Insert Output Level (optional) :
+0dBu unbalanced, output impedance <50•
Insert Return Level (optional) : +0dBu unbalanced, input impedance 10k•
Limiter :
from infinite to -30dB below internal nominal level
attack time: .......us, release time: ..ms (programm dependent?)
Compressor (VCA version) :
attack time: ..... us, release time: ........ ms