Sanyo VMC-8618 - Manual (Page 5)

PRECAUTION
If an abnormality does occur, turn the power switch off and
unplug the unit. Have a qualified technician perform any
repairs.
Do not use the monitor if it makes a strange noise, emits a
strange odor, or if smoke comes out from it
If used under these conditions, the monitor may cause a fire or
electric shock. Immediately unplug it and wait to make sure no
more smoke comes from it. Then take it to the dealer for service.
Do not try to repair or open the monitor yourself.
Do not allow the power cord to get damaged
• Do not place heavy objects on the power cord.
• Do not place the power cord near a heat source.
• Do not excessively bend the power cord, modify it, or secure
it with staples.
Doing so may damage the power cord and cause a fire or
electric shock.
If the power cord is damaged, take it to the dealer and have it
replaced.
Do not allow dust or dirt to build up on the
power cord or power outlet
A build-up of dust may cause a short circuit or generate heat
and cause a fire.
Be especially careful when using the monitor in areas of high
humidity, in areas with frequent condensation, in kitchens, and in
places where there is excessive dust.
Periodically unplug the power cord and clean away the dust that
builds up between the plug terminals.
Cautions when plugging in the power cord
• Make sure you insert the plug of the power cord all the way in
the power outlet. Using the monitor with the power cord not
fully plugged in may cause heat to generate and cause a fire.
• Do not use the monitor with the power cord wound or tied up.
Heat may generate and cause a fire.
• When using an extension cord, be sure that the total current load
of all equipment connected to it dose not exceed the specified
ratings of the extension cord. If the rating are exceeded, heat may
generate and cause a fire. Make sure to carefully read the
specifications accompanying the extension cord.
Cleaning
• Dirt can be removed from the cabinet by wiping it with a soft
cloth. To remove stains, wipe with a soft cloth moistened with
a soft detergent solution and wrung dry, then wipe dry with
dry soft cloth.
• Do not use benzine, thinner or other chemical product on the
cabinet, as that may cause deformation and paint peeling.
Before using a chemical cloth, make sure to read all
accompanying instructions. Make sure that no plastic or
rubber material comes in contact with the cabinet for a long
period of time, as that may cause damage or paint peeling.
SERVICE
This unit is a precision instruments and if treated with care, will
provide years of satisfactory performance. However, in the event
of a problem, the owner is advised not to attempt to make
repairs or open the cabinet. Servicing should always be referred
to your dealer or Sanyo Authorized Service Centre.
CONTENTS
PARTS NAMES . . . . . . . . . . . . . . . . . . . . . . . 4
CONNECTION . . . . . . . . . . . . . . . . . . . . . . . . 6
BASIC OPERATION . . . . . . . . . . . . . . . . . . . 7
ADJUST THE OSD MENU ITEM . . . . . . . . . . 8
LANGUAGE SCREEN TABLE . . . . . . . . . . . 11
TROUBLESHOOTING . . . . . . . . . . . . . . . . . . 13
SPECIFICATIONS . . . . . . . . . . . . . . . . . . . . . 14
FEATURES
Equipped with video and audio input
terminals
The video and audio input terminals (two systems for each
input) allow bridge connections.
Equipped with Y/C input (S-VIDEO input)
terminal
This terminal is used to input Y/C separation signals
(S-VIDEO signals).
L8MV5/US, L8MW5/US (VMC-8618, 8613 GB) 2001. 2. 23
3